Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterNikro Air Duct Cleaning in Leander: What to Know First
CleanRun Air Duct Cleaning Leander provides independent Nikro air duct cleaning for homeowners in Leander and nearby areas, with most residential jobs completed in a single scheduled visit and a written price delivered before any panel comes off. We are not affiliated with or authorized by Nikro. Our crews use Nikro-compatible negative-pressure extractors and rotary brush systems alongside our Rotobrush and Abatement Technologies equipment, and every duct run is photographed before and after as part of the standard job record. If you own a Nikro system and want to know what condition your ductwork is actually in, call (737) 252-1285 for a free estimate with no obligation.
How Nikro Products Fail - and How We Fix Them
- Nikro SL2000 Series portable extractors: The vacuum motor seals harden faster than spec in Central Texas heat, especially when the unit sits in an unconditioned garage between jobs. We see this in Leander homes near Crystal Falls where summer attic temperatures exceed 140°F. Our fix: test static pressure at the unit before quoting, replace the motor seal with a high-temp Viton equivalent if degraded, and document the reading on your job record.
- Nikro PDC2000 power duct cleaners: The flexible drive cable binds at the first elbow in older Leander homes with 6-inch galvanized ductwork, common in pre-2015 builds near Bagdad Road. The cable frays internally before showing external wear. We pull the cable, measure runout with a dial indicator, and replace with OEM spec or a verified aftermarket equivalent - never run a suspect cable into your plenum.
- Nikro HEPA-AIRE portable containment systems: The HEPA filter loading indicator drifts out of calibration in high-pollen environments, which in Leander means cedar season (December through February) and oak season (March through April). A false green light leaves you with compromised filtration. We verify with a digital manometer across the filter bank and replace the indicator assembly if variance exceeds 0.5 inches water column.
- Nikro SL4000 series with integrated compressor: The moisture separator fails to drain fully in Leander’s humidity spikes, particularly after spring storms roll off the Hill Country. Water carryover into the vacuum motor causes bearing corrosion we catch during pre-job inspection. We purge the separator, test the auto-drain solenoid, and replace it with a brass-body unit if the original plastic fitting shows stress cracking.
- Nikro air scrubber recirculation units: The UV-C lamp socket oxidizes in homes with active cedar pollen infiltration, creating intermittent contact that shows up as flickering status lights - not full failure, but reduced irradiance. We measure UV output with a calibrated radiometer and replace the ceramic socket with a nickel-plated version that resists the sulfur compounds in Leander’s airborne pollen load.
Our Nikro Air Duct Cleaning Process
- 1
Inspection and documentation. We feed a borescope through each register and the plenum - the main distribution box where your trunk lines connect - and photograph what we find. Tomas Reyes started this practice after years in the Northeast; he pulls the inspection camera out before quoting anything. If it doesn’t show up on screen, we don’t charge for it.
- 2
Written price delivery. Haven Standard Clause 1: the price is written and agreed before any work starts. No exceptions. Your estimate specifies which Nikro-compatible equipment we’ll use, how many duct runs, and whether plenum access or register replacement is needed.
- 3
Negative-pressure extraction with rotary agitation. We seal each register and apply negative pressure - suction that pulls loosened debris toward the collection point - while a rotary brush scrubs the duct walls. For Nikro systems, we match brush diameter to duct size per Nikro’s own engineering tables, not guesswork.
- 4
Component-specific service. If your Nikro unit has a serviceable HEPA stage, moisture separator, or drive cable, we address what the inspection revealed. OEM parts when available; quality aftermarket when lead times stretch past reasonable, with your approval in writing.
- 5
Post-clean verification and photo record. We re-run the borescope through each duct run and deliver before-and-after images as part of your job record. The 365-Day Done Right Promise goes into writing: if the work is not right, we make it right.
- 6
System restart and static pressure check. We verify your HVAC system restarts without abnormal load, measure static pressure at the air handler, and note the reading on your documentation. Abnormal readings get flagged for follow-up before we leave.
BeforeAfterWhat Nikro Air Duct Cleaning Costs in Leander
Most residential Nikro air duct cleaning jobs in Leander fall between $420 and $780 for a complete system, with the final figure set by what the inspection actually shows.
| Scenario | Typical Range |
|---|---|
| Standard 3-4 bedroom home, 12-18 duct runs, no access issues | $420 - $580 |
| Home with Nikro HEPA-AIRE filtration stage requiring filter service or replacement | $580 - $720 |
| Older Leander home with 6-inch galvanized ductwork, multiple elbows, register replacement needed | $650 - $780 |
| Commercial Nikro system or multi-zone residential with plenum modification | $780 - $1,200+ |
What moves the price: duct run count, accessibility (crawl space vs. attic vs. conditioned space), whether the plenum requires hand-cleaning, and any Nikro-specific component service like HEPA filter replacement or drive cable renewal. We do not quote per-vent pricing - one flat price per system, agreed in writing before work starts. Call (737) 252-1285 for an exact quote; estimates are free.
Why Leander Homeowners Call CleanRun Air Duct Cleaning Leander for Nikro Work
We’ve run crews through Leander since 2013, including regular jobs in Crystal Falls where new-construction debris and cedar pollen create duct conditions you can see on camera without enhancement. Our technicians are background-checked, uniformed, and identified by name before arrival - Haven Standard Clause 3: Verified Crews. The equipment roster includes Nikro-compatible systems alongside Rotobrush, Abatement Technologies, Honeywell, Aprilaire, and Guardsman, so we’re not single-brand dependent if your job calls for a different approach. We also service Lennox, Trane, and Carrier systems, which matters in Leander homes where the HVAC brand and duct cleaning equipment brand don’t match. Every job carries the 365-Day Done Right Promise in writing, and we deliver a Documented Photo Record of every duct run before we leave. Show the photo first. Then talk about what comes next.
FAQs
No. As an independent Nikro service provider, we perform cleaning and maintenance that does not alter factory specifications or use non-approved consumables in ways that would affect warranty coverage. We document our process and materials on your job record in case warranty questions arise later. If you have a specific warranty concern, call us at (737) 252-1285 and we’ll review your documentation before scheduling.
Persistent dust accumulation on registers within weeks of surface cleaning, uneven airflow between rooms, or a musty odor when the system cycles on are the three most common indicators we see in Leander homes. We verify with a borescope inspection - the camera shows a 3-inch debris build-up at the first elbow, or it doesn’t. The inspection is included in our free estimate.
For portable extractors under five years old, repair is usually cost-effective if the vacuum motor and housing are sound. For units over eight years with multiple component failures - motor seal degradation plus cable binding plus filter housing cracks - replacement often makes more sense. We give you both numbers in writing and let the math decide.
Most residential jobs run three to five hours from arrival to final documentation, depending on duct run count and what the inspection reveals. We schedule a specific arrival window, not a vague “morning or afternoon” block, and we call 30 minutes before arrival.
The $79 coupon model typically covers a brief vacuum at the register with no register removal, no plenum access, no photography, and no written guarantee. We quote whole-system cleaning with documented results. If you have a competitor’s written estimate, bring it - Haven Standard Clause 7 gives you a Free Second Opinion, our number next to theirs, no obligation.
Written by Tomas Reyes, Owner, CleanRun Air Duct Cleaning Leander at CleanRun Air Duct Cleaning Leander, serving Leander and nearby areas.