Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Guardsman Register & Grille Cleaning: The Leander Owner’s Guide
Guardsman register and grille cleaning in Leander typically runs $140-$260 per system for full removal, cleaning, and reinstallation with a documented photo record, and we stock Guardsman-compatible hardware on every truck. Most Leander homeowners discover the problem when airflow drops in one room or the grille rattles against the boot every time the AC cycles on. The cedar pollen season here, running February through April, packs fine debris behind registers in newer homes especially, and that buildup is what forces the grille out of square or seizes the damper blade.
Which Guardsman Models This Applies To
Guardsman registers and grilles fall into three product families you’ll see in Leander homes: the standard stamped-steel 500 series, the heavier-gauge 700 series with integrated opposed-blade dampers, and the architectural aluminum line used in higher-end builds around Crystal Falls and Travisso. The 500 series measures 2-1/4 inch face depth with a 1/2 inch margin; the 700 series runs 2-5/8 inch with a 3/4 inch margin and a distinct raised bead around the perimeter. Check the backside of the grille face for an embossed “GM-” prefix followed by four digits, or look for a paper label on the damper box itself if the register is still mounted.
We carry both OEM Guardsman hardware and quality aftermarket equivalents from Hart & Cooley and Shoemaker. The aftermarket dampers mate cleanly with Guardsman boots in most Leander installations from 2015 forward, but pre-2014 builds with the original snap-in damper box sometimes need the OEM clip geometry. We measure the boot throat and test-fit before quoting, Haven Standard Clause 1, so you’re not paying for a part that doesn’t seat.
Signs Your Guardsman Register & Grille Cleaning Is Failing

- Uneven airflow or a dead zone in one room. The opposed-blade damper inside a 700-series register jams when pollen and drywall dust pack the pivot pins. In Leander’s new-construction zones, we’ve pulled grilles that were 40% blocked at the blade hinge before the homeowner ever noticed reduced flow.
- Rattling or whistling when the system cycles. The grille face loosens in its friction clips as debris wedges between the face and the boot rim. The sound changes pitch with fan speed, which distinguishes it from duct-flex noise deeper in the run.
- Visible mold or discoloration on the grille face. Guardsman’s powder-coated steel holds up well, but the backside of a 500-series register in a humid return-air application can spot-corrode where condensation collects behind packed debris. The camera shows it before we touch a screw.
- Damper lever stuck or stripped. The plastic quadrant on older 500-series units cracks when forced against a debris-bound blade. Once the lever spins free, the damper defaults to whatever position it was last in, usually full closed or full open.
- Grille face won’t seat flush after filter changes or painting. The friction clips fatigue, but more often the boot rim has deformed from repeated removal with debris trapped behind it. We check square and clip tension before deciding whether the fix is cleaning, clip replacement, or boot repair.
Before
AfterReplacement Cost & What’s Included
| Service | Price Range |
|---|---|
| Register & grille removal, deep cleaning, reinstallation (per register) | $45-$75 |
| Full system cleaning: all supply and return registers (typical 8-12 count) | $140-$260 |
| Damper box or clip replacement with OEM Guardsman hardware | $85-$140 per unit |
| Boot repair or replacement where rim is deformed | $160-$280 |
What drives the range: register count, whether dampers need rebuild or just cleaning, and whether the boot itself needs attention. Every quote is written before work starts, Haven Standard Clause 1. The 365-Day Done Right Promise covers the labor and any hardware we install. CleanRun Duct Repair & Cleaning is an independent service provider, not affiliated with Guardsman.
DIY or Call Us?

An owner can safely vacuum the face of a register with a brush attachment and wipe the visible surfaces. What you cannot do without the right tools: remove the grille without stressing the friction clips, inspect the damper blade pivot for debris packing, or evaluate whether the boot rim is still square. We’ve replaced too many grilles in Leander where a homeowner cracked the quadrant forcing a stuck lever, turning a $60 cleaning into a $140 damper rebuild.
The other risk is what you don’t see: the debris behind the register is often the visible tip of buildup deeper in the duct run. We photograph every boot throat and the first two feet of duct behind it before quoting anything else. Show the photo first. Then talk about what comes next. If you’re seeing any of the symptoms above, call (737) 252-1285 and we’ll put the camera in before you decide on anything.
FAQs
Steel registers last 15-25 years with periodic cleaning, but the damper quadrants and friction clips often need attention at 8-12 years. Cedar pollen and caliche dust in the Leander area accelerate pivot wear because fine grit works into the blade hinges every season. Call (737) 252-1285 for an exact quote - estimates are free.
Yes, if the issue is debris binding or clip fatigue. We clean and lubricate pivots, replace individual clips, and rebuild damper quadrants with OEM Guardsman parts. Replacement only makes sense when the face is corroded, the boot rim is deformed, or the homeowner wants to upgrade to the 700-series opposed-blade damper for better zone control. Call (737) 252-1285 for an exact quote - estimates are free.
Single register: 20-40 minutes including camera inspection of the boot throat. Full system of 8-12 registers: 2.5-4 hours with documented photo record of every run. We don’t rush the inspection because what we find determines whether you’re paying for cleaning or something more. Call (737) 252-1285 for an exact quote - estimates are free.
We stock common 500-series and 700-series grille faces, damper quadrants, and friction clips. Architectural aluminum line and specialized sizes we pull from our Austin-area supplier, usually same-day. We verify fit at your boot before any part is opened or billed, Haven Standard Clause 1. Call (737) 252-1285 for an exact quote - estimates are free.
Written by Tomas Reyes, Owner, CleanRun Air Duct Cleaning Leander at CleanRun Air Duct Cleaning Leander, serving Leander and nearby areas.




Before
After
Before
After